|
|
|
Rear Control Arm Spherical Bearing Bushing Kit (for 510 & 610 w/IRS)
This kit consists of four (4) spherical bearings, eight (8) steel step bushings, eight (8) flat washers and eight (8) bearing retaining sleeves. This will replace the OE rubber pivot bushings on both rear trailing arms with spherical bearings. The kit is specially machined to allow use of the original factory pivot bolts.
The bearing retaining sleeve OD is machined to close tolerances for a slip fit into the trailing arm. The retainers are not a press fit and once properly located the outer edge of the retainer should be welded to the trailing arm to keep them permanently positioned.
|
|
|
|