|
|
|
The FutoFab adjustable lower control arm is made of billet 6061-T3 aluminum and then black anodized. They are designed to be used with the stock ball joint and sway bar links and bolt to the chassis without modification. Please check that that your ball joint mounting bolts are long enough. If not alternate length bolts may need to be sourced as the mounting area on the FutoFab Adjustable LCA is much thicker than the original Datsun part. (TC Rod sold seperately)
|
|
The inner pivot point on the FutoFab adjustable LCA uses a chrome plated, slot loaded rod end with specially machined stainless steel high mis-alignment spacers for use with the stock control arm mounting hardware.
|
|
The FutoFab design allows for adjustment without having to remove the control arm. The adjuster has right and left hand threads. By loosening the jamb nuts and turning the adjuster the control arm will lengthen or shorten based on the direction the adjuster is turned. Shown in this inmage with optional rod end boots.
|
|
The FutoFab LCA and TC Rods can be combined for a fully adjustability front suspension.
|
|
|
|