|
Spacers and Extended Length Studs
All FutoFab spacers have a 3.0" diameter bore and 6.0" OD with 4x114.3 (4x4.5") bolt patterns.
Our spacers and extended length studs are designed to add that final adjustment to your wheel offset. Spacers can be used to fill out a fender well or to add tire to strut tube clearance if you swap over to 280ZX brakes/struts.
Shown here are 5/16" (8mm) spacers with 12mm stud holes and M12x1.25 - 60mm long studs.
|
|
Datsun Roadsters - Allows proper fit of 73mm center bore wheels
These 1/8" (3mm) spacers are designed to exactly fit the Datsun Roadster front hubs with 7/16” studs. They provide just enough spacing to allow installation of the common 73mm center bore wheels without modification. They can also be used in other applications but the stud holes may need to be enlarged for proper fit.
Offered spacers only or with eight (8) or sixteen (16) 7/16-20, 1.75" long studs (+1/2" longer than stock)
|
|
Datsun Roadster Studs (black oxide finish)
Our Datsun Roadster 7/16-20 studs are 1.75" long, 1/2" longer than OE studs.
They have a .475" knurl with a black oxide finish.
|
|
Datsun Z Cars and 510 Studs (gold cadmium finish)
Our M12x1.25 studs are 60mm long, as much as 28.5mm longer than stock.
Their 12.90mm knurl will fit not just Z Cars and 510's but most Datsun/Nissan vehicles. They are finished in a gold cadmium corrosion resistant finish. |
|